R&L Electronics
Text Questions to
513-868-6399
800-221-7735

   Catalog » Test Equipment » MISC » TINYSA My Account | Cart Contents | Checkout   


Search
 
Use keywords to find the product you are looking for.
Advanced Search
Icom
Jetstream
Kenwood
MFJ
Yaesu

Used Equipment

Links

Screen Savers
Brand
Email
Email
Subscribe to our email list
Unsubscribe to our email list
Catalog
Request Catalog
Download eCatalog
Store Info
FAQ
Map to Store
Special Events
Store Hours

TINYSA TINYSA
[TINYSA]

$69.95

100kHz-960MHz Spectrum Analyzer 2.8" Touchscreen

This item is currently in stock.


ESD Protected

Specification

User interface:

* Display resolution 320*240 pixels
* Screen diagonal 2.8"
* 16 bits per RGB pixels
* Resistive touch control
* Jog switch control
* USB serial port control
* Optional TTL USART port (SW not yet implemented) on the internal PCB
* Linear power supply to avoid switching noise.

The input/output specification of the tinySA is split over the 4 modes

Low input mode spec:

* Input frequency range from 100kHz to 350MHz
* Input impedance 50 ohm when input attenuation set to 10dB or more.
* Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps
* Absolute maximum input level without attenuation of +10dBm
* Absolute maximum input power with 30dB attenuation of +20dBm for short period
* Input Intercept Point of third order modulation products (IIP3) with 0dB attenuation of +15dBm
* 1dB compression point at +2dBm with 0dB attenuation
* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB
* Absolute power level accuracy after power level calibration of +/- 1dB
* Lowest discernible signal using a resolution bandwidth of 30kHz of -102dBm
* Frequency accuracy equal to the selected resolution bandwidth
* Phase noise of -90dB/Hz at 100kHz offset and -115dB/Hz at 1MHz offset
* Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB
* Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.
* On screen resolution of 145 or 290 measurement points.
* Scanning speed of over 1000 points/second using largest resolution filters.
* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth
* Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal

High input mode spec:

* Input frequency range from 240MHz to 960MHz
* As there is no input bandfilter strong signals outside the 240MHz to 960MHz range can cause distortion of the in band signals
* Absolute maximum input level without attenuation of +10dBm
* Input Intercept Point of third order modulation products (IIP3) of -5dBm
* 1dB compression point at -6dBm with 0dB attenuation
* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB
* Absolute power level accuracy after power level calibration of +/- 1dB
* Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm
* Frequency accuracy equal to the selected resolution bandwidth
* Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB
* Selectable (automatic and manual) resolution filters of 3, 10, 30, 100, 300 and 600kHz
* Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +/- 15dB
* On screen resolution of 145 or 290 measurement points.
* Scanning speed of over 1000 points/second using largest resolution filters.
* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth

Low output mode spec:

* Sinus output with harmonics below -40dB of fundamental
* Output frequency range from 100kHz to 350MHz
* Output level selectable in 1dB steps between -76dBm and -6dBm
* Optional AM, narrow FM and wide FM modulation or slow sweep over selectable frequency span

High output mode spec:

* Square wave output
* Output frequency range from 240MHz to 960MHz
* Output level selectable in variable increments between -38dBm and +13dBm
* Optional narrow FM and wide FM modulation or slow sweep over selectable frequency span

Reference generator spec:

* Optional square wave output with fundamental at -25dBm connected to high input/output
* Frequency can be set to 1MHz, 2MHz, 4MHz, 10MHz, 15MHz or 30MHz.

Battery spec:

* Charging time max 1 hour on 500mA minimum USB port or USB charger
* Operation on fully charged battery for at least 2 hours



















Optional Accessories

JETSTREAM JT4120SMA MALE TO N FEMALE $ 3.95Buy JT4120
JETSTREAM SMABNCSMA TO BNC $ 3.50Buy SMABNC
JETSTREAM SMAUHFSMA TO UHF/PL259 $ 4.95Buy SMAUHF
TINYSA TINYSAANTREPLACEMENT ANTENNA $ 9.95Buy TINYSAANT
100kHz-960MHz Spectrum Analyzer 2.8" Touchscreen MISC TEST EQUIPMENT

 

Shopping Cart more
0 items
Manufacturer Info
Other products


Follow us on Facebook



YAESU
FTDX10

HF TRANSCEIVER
$1379.95
Until 06/30/24


ANYTONE
AT778UV

2m/70cm Dual Band Mobile
$129


ICOM
IC9700

2m/70cm/1.2ghz
$1749.95
Until 06/30/24

Amplifiers and Preamps
HF Amplifiers
2m Amps/Preamps
Antennas
Multiband HF Base
Multiband HF Mobile
Multiband HF Portable
2m Base
2m Mobile
Multiband VHF/UHF Base
Multiband VHF/UHF Mobile
Multiband HF/VHF/UHF Mobile
Antenna Accessories
Duplexers
Triplexers
Rotators
Antenna Mounts
Magnet Mounts
Lip Type Mounts
Antenna Tuners
HF Automatic
HF Manual
Books
Study Guides

Cable, Coax, Wire
HT Jumpers
Ground Wire
Ladderline
Mini 8/RG8X w/Connectors
RG8 w/Connectors
Rotator Cable
Connectors
Adapters
Connector End
Power Supplies
Switching 15-40 amps
Transformer 15-40 Amps
Wall Cubes
Radios
2m Handhelds
2m/70cm Handhelds
2m Mobile
2m/70cm Mobile
HF Base
HF/VHF Base
Multiband HF/VHF Mobile
Radio Accessories
Clocks
Coax Switches
External Speakers
Lightning Arrestors
SWR Analyzers
TNC/Sound Card Interfaces
Wattmeters
Tower
Rohn 25G type
Rohn 45G Type

Copyright © 2024 R&L Electronics
1315 Maple Ave
Hamilton, Ohio 45011
800-221-7735
513-868-6574 Fax
sales@randl.com